:	Nov 18, 2005

.

Raise and support the vehicle.

.

Remove the front RH splash shield.   Remove the 4 clips.

.

Remove the front LH fender splash shield.

.

Remove the radiator access panel.   Remove the 4 bolts.

.

: Always plug any open connections to prevent contamination. Disconnect the high pressure line from the power steering pump.   Loosen and release the power steering pump line.   Allow the fluid to drain into a container.   Remove and discard the 2 sealing washers.

.

Release the power steering line support bracket.   Remove the nut.   Release the hose.

.

Disconnect the high pressure line from the power steering gear.   Remove the bolt.   Release the power steering gear line.   Remove and discard the O-ring seal.

.

Remove the steering gear high-pressure line.

.

Install the steering gear high-pressure line.

.

Connect the high-pressure line to the power steering gear.   Install the O-ring seal.   Attach the power steering gear high-pressure line.   Tighten the bolt to 25 Nm (18 lb.ft).

.

Install the power steering line support bracket.   Tighten the nut to 10 Nm (7 lb.ft).   Secure the hose with the clip.

.

: Always plug any open connections to prevent contamination. Connect the high-pressure line to the power steering pump.   Install new sealing washers.   Connect the power steering pump high-pressure line.

.

Install the radiator access panel.   Tighten the bolts to 10 Nm (7 lb.ft).

.

Install the front LH fender splash shield.

.

Install the front RH splash shield.   Secure with the clips.

.

Fill and bleed the power steering system.